Milwaukee V28 Manual Del Operador página 6

changing Blades
1. R E M o V E B AT T E RY PA C K B E -
FoRE CHANGING oR REMoVING
BLADES.
2. Turn the tension lock handle located on
the front of the saw 180° counterclock-
wise. This releases the tension on the
blade for easy removal.
3. Remove the blades from the pulleys first
and then from the guides.
4. To install a new blade, with the pulleys
facing up, insert the blade between the
rollers and the faces of the guides, mak-
ing sure that the teeth on the left side
of the tool point towards the rear of the
tool.
5. With one hand, hold the blade in place
between the rollers and the guides and
use the other hand to position the blade
around the pulleys. Be sure that the
blade lies freely within the guard channel
before starting the tool motor.
6. Turn the tension lock handle 180° clock-
wise to lock the position. This will secure
the blade on the pulleys.
Be sure tHat tHe BLade is prop-
erLY seated on tHe puLLeYs
Before startinG tHe cut.
operaTion
to reduce the risk of injury, keep hands
away from the blade and other moving
parts. always wear safety goggles or
glasses with side shields.
High/Low/Trigger Lock Switch
To set the maximum speed or lock the trigger,
allow the motor to come to a complete stop
then move the high/low/trigger lock switch to
the following positions:
fig. 3
High Speed
Max 350 SFPM
For low speed (Maximum 225 SFPM): Push
in the control switch from the left side of the
tool. To vary the speed up to 225 SFPM, in-
crease or decrease pressure on the trigger.
For high speed (Maximum 350 SFPM):
Push in the control switch from the right
side of the tool. To vary the speed up to 350
SFPM, increase or decrease pressure on
the trigger.
To lock the trigger: Push the control switch
to the center position. The trigger will not
work while the switch is in the locked posi-
tion. Always lock the trigger and remove the
battery pack before performing maintenance
and when changing accessories. Lock the
trigger when storing the tool and when the
tool is not in use.

warning
Trigger Low Speed
Lock Max 225 SFPM