Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
starting, stopping and controlling
speed
1.
To start the tool, grasp the trigger handle
and front handle firmly and pull the trig-
ger.
Note: LED light turns on when the
trigger is pulled.
2.
To vary the speed, increase or de-
crease the pressure on the trigger. The
further the trigger is pulled, the greater
the speed. The maximum SFPM is
determined by the high/low/trigger lock
switch.
3.
To stop the tool, release the trigger. Al-
low the tool to come to a complete stop
before removing the blade from a partial
cut or laying the tool down.
electric Brake
The electric brake engages when the trigger
is released, causing the blade to stop and al-
lowing you to proceed with your work. Gener-
ally, the saw blade stops within two seconds.
However, there may be a delay between
the time you release the trigger and when
the brake engages. occasionally the brake
may miss completely. If the brake misses
frequently, the saw needs servicing by an
authorized MILWAUKEE service facility.
typical application
fig. 4
Correct
1.
Keep the blade off the workpiece until
the motor has reached the selected
speed.
2.
Start cutting on a surface where the
greatest number of teeth will be in
contact with the workpiece at one time
(Fig 4).
3.
Place the work steady rest against the
workpiece and lower the moving saw
blade into the cut.
4.
Do not bear down while cutting. The
weight of the tool will supply adequate
pressure for the fastest cutting.
5.
When completing a cut, hold the tool
firmly so it will not fall against the work-
piece.
cold weather operation
The V8 Lithium-Ion battery pack can be
used in temperatures down to -4°F. When
the battery pack is very cold, it may pulse for
the first minute of use to warm itself up. Put
the battery pack on a tool and use the tool in
a light application. After about a minute, the
pack will have warmed itself up and operate
normally.
Incorrect
Publicidad
Tabla de contenido
