Installing The Oven; Electric Connection - Midea ESK 2875 BL Manual De Usuario

Installing the oven

• Setup the cabinet base for the installation of the stove referring to the
dimensions in " Fig.1 ".
• Connect to the mains referring to " Electric connection " .
• Insert the oven partway into the previously prepared cabinet base and connect
to the hob referring to the chapter " Connecting the hob ".
• Then push the oven completely into the cabinet. Make sure not to impede (bend,
squeeze, or twist) the cables.
• Attach or secure the oven to the respective xtures using the two screws.
Opening the oven door will uncover the designated mounting holes on the left
and right of the frame.

Electric connection

WARNING
• Have the device connected to the mainsonly by an authorized expert. The
installation must follow the applicable standards and regulations.
• Connecting the device to a normal wall socket or using multiple sockets or
extension cables is not permitted.
Information for authorized experts:
• Instructions regarding different connection methods are located on the rear
panel of the device next to the terminal box of the oven.
• Before connecting the device, make sure the local voltage matches the
speci cations on the rating label.
• Make sure to connect the protective ground to the terminal of the marked
terminal block. The electric connection of the oven should incorporate an
emergency switch for disconnecting the entire device from the mains in case
of an emergency. The distance between the normally open contacts of the
emergency switch must be of at least 3 mm.
• The device is suitable for three-phase and AC current (400V 3N~50Hz).
• The heating elements have a nominal voltage of 230V. The device can be
adjusted for single-phase current (230V) by a respective bypass on the
terminal block, based on the circuit diagram below. Select a suitable cord as
mains cable, considering the connection type and nominal power of the oven.
• Fix the mains cable in the tension relief.
• Guide the mains cable in such a way that it does not get in contact with any
hot components of the device. Do not lead it over sharp edges or corners.
screw
BRACKET
bracket
base
screw hole
HOB
BRACKET
 EN-18 
TABLE