soapy water or vinegar-based cleaner before hand.
• Clean the stainless steel surfaces with warm soapy water or with a commercial
stainless steel cleaning product.
• Do not use any scrubbing agents or sponges. During too intensive cleaning,
these could damage the markings(on the oven control panel), rendering them
unreadable.
• Clean the glass front with warm water and some detergent. Do not use creamy
cleaning liquids.
• Observe the use and safety instructions of the commercial oven cleaner.
• Use a soft, absorbing cloth for drying after cleaning.
Cleaning the racks
Always remove the racks when you want to thoroughly clean the oven walls. Soak
the removed racks to make cleaning easier. It is also possible to clean the racks in
the dishwasher.
• Hold the lower edge of the rack and pull it half way out.
• Then lift the rack and pull it from the mounting holes.
Removing the oven door
You may remove the oven door to facilitate cleaning and to get better access to
the oven interior.
• Open the door completely.
• Push the folding clamps of the hinges on both sides upwards.
Replacing the oven lamp
NOTE
Only use 25-40W/220V-240V , T300°C halogen lamps.
EN-29
• Slightly close the door and then lift it up to remove it.
• To reinstall the door, follow the above procedure in
reverse order.
• When reinstalling the door, make sure the touch of
the hinge is properly aligned with the protrusion of
the hinge holder.
• Then press down the folding clamps. If you forget to
do so, the hinges could get damaged when closing
the oven door.
For replacement, process as follows:
• Disconnect power from the mains outlet or switch
off the circuit breaker of the unit's mains outlet.
• Unscrew the glass lamp cover by turning it counter-
clockwise (note, it may be stiff) and replace the bulb
with a new one of the same type.
• Screw the glass lamp cover back in place.