Midea ESK 2875 BL Manual De Usuario página 188

Preparing the worktop for installation of the hob
• The worktop of the furniture must be of 30 to 40 mm in thickness and at least
600 mm in depth. It must be horizontal and the side facing the wall must be
isolated against spilling liquids or humidity.
• The cut surfaces (cutoutedges) must be sealed with special varnish, silicone
rubber, or cast raisin in order to prevent swelling caused by humidity.
• The hob must be framed by at least 5 cm of worktop.
• Clean the cutout area of the worktop.
Fig. 2
Prepare the cutout of the worktop using the dimensional drawing.
Attach the sealing to the bottom of the hob frame before installing the hob.
SEAL
Installing the hob
• Check the hob sealing for any damage and for correct positioning on the hob.
• Place the hob with the cables rst into the prepared cutout of the worktop.
• Attach the hob to the worktop bottom using the four brackets and screws
provided. Insert the screws into the four holes on the bottom of the hob and
tighten them.
• Position and adjust the brackets depending on the thickness of the worktop.
 EN-17 
screw
bracket
base
screw hole
BRACKET
HOB
TABLE
Fig. 2