Assembly Preparation; Assembly Instructions; Mounting The Legs; Assembling The Base Ring - Pit Boss PB410FP Montaje Y Operación

Brasero/parrilla circular
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Parts are located throughout the shipping carton, including inside the fire bowl. Unpack the unit
and parts by removing all packaging materials. Before assembly, review all parts and reference the
parts list. If any part is missing or damaged, do not attempt to assemble. Shipping damage is not
covered under warranty. Contact your dealer or Pit Boss® Customer Care for parts.
Tool required for assembly: Phillips screwdriver (not included) and wrench (included).
1.

MOUNTING THE LEGS

Parts Required:
1
x
Fire Bowl (#11)
4
x
Leg (#14)
12
x
Screw (#A)
Installation:
Place a piece of cardboard on the
floor to prevent scratching the unit
and parts during assembly.
Mount a Leg to the Fire Bowl using
three screws through the pre-
drilled holes. Install screws from the
inside of Fire Bowl. Repeat the same
procedure for other Legs.
IMPORTANT: Do not tighten the screws
until the base ring is mounted on the
legs, then tighten all the screws.
2.

ASSEMBLING THE BASE RING

Parts Required:
4
x
Base Ring (#13)
4
x
Screw (#A)
Installation:
Insert one Base Ring into another
and fasten them with screw. Repeat
the same procedure to install the
other two Base Rings.
IMPORTANT: Ensure all inside brackets
are facing the same direction.
6

ASSEMBLY PREPARATION

www.pitboss-grills.com
USA: (480) 923-9630 | Canada: 1-877-942-2246

ASSEMBLY INSTRUCTIONS

1
A
11
14
14
2
13
13
13
A
14
14
A
13

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

1073010890

Tabla de contenido