Assembly Preparation; Assembly Instructions; Connecting The Wheels To The Legs - Pit Boss Ultimate PB3BGD2 Guía De Montaje

Ocultar thumbs Ver también para Ultimate PB3BGD2:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16
Parts are located throughout the shipping carton, including underneath the griddle. Inspect the unit, parts, and hardware blister
pack after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the griddle
before assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt
to assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss® Grills Customer Care.
IMPORTANT: To ease installation, using two people is helpful (but not necessary) when assembling this unit.
Tools required for assembly: screwdriver and wrench. Tools not included.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed. Hardware combination involving a locking washer and
washer should be installed with the locking washer closest to the head of the screw.

1. CONNECTING THE WHEELS TO THE LEGS

Parts Required:
1
x
Support Leg for Caster / Front (#17)
1
x
Support Leg for Caster / Back (#18)
1
x
Support Leg for Wheel / Front (#19)
1
x
Support Leg for Wheel / Back (#20)
2
x
Locking Caster (#22)
2
x
Wheel (#23)
2
x
Wheel Cotter Pin (#E)
2
x
Wheel Washer (#F)
2
x
Wheel Axle Pin (#G)
Installation:
Attach the Wheel to the Support Leg for Wheel by inserting the Wheel
Axle Pin through the Wheel, Support Leg hole, Wheel Washer, then
secure using the Wheel Cotter Pin. Repeat installation for the other
Support Leg with Wheel. Note illustration 1A.
Install a Locking Caster Wheel to the bottom of a Support Leg by
hand-tightening into the hole. The Locking Caster Wheel is inserted
completely when it cannot rotate any further into the Support Leg.
Repeat installation for second Support Leg. Note illustration 1B.
4

ASSEMBLY PREPARATION

www.pitboss-grills.com

ASSEMBLY INSTRUCTIONS

1A
19
20
G
E
23
F
1B
17
18
22

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

108101081110812

Tabla de contenido