Assembly Preparation; Assembly Instructions; Installing The Bottom Shelf - Pit Boss AUSTIN XL Instrucciones De Montaje Y Funcionamiento

Tabla de contenido

Idiomas disponibles

Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister

pack after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill

before assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt

to assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss Customer Care for parts.

IMPORTANT: To ease installation and avoid injury, use two people when assembling this appliance.

Tools required for assembly: screwdriver and level. Tools not included.

IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws

completely until all screws for that step have been installed. Hardware combination involving a locking washer and

washer should be installed with the locking washer closest to the head of the screw.

1. INSTALLING THE BOTTOM SHELF

Parts Required:

Support Leg Foot (#14)

Support Leg for Locking Caster Wheel (#15)

Support Leg for Wheel (#16)

Bottom Shelf (#22)

Screw (#A)

Locking Washer (#C)

Washer (#B)

Screw (#G)

Installation:

•

Secure one support leg foot to the bottom of a support leg for locking

caster wheel using three screws. Repeat installation for other support leg

foot. Next, place a piece of cardboard on the floor to prevent scratching

the unit and parts during assembly. Prepare the four support legs for

installation, arranging the labeled legs as shown in illustration 1A.

IMPORTANT: The four support legs must be arranged correctly to be

able to properly install the cart support plates in a later step.

•

Attach the bottom shelf to one support leg by carefully aligning it into

the slotted corner of the support leg, then secure using one screw.

Repeat installation for the other three support legs to the remaining

three corners of the bottom shelf. Note illustration 1B.

NOTE: Ensure the flat surface of the bottom shelf is facing up.

•

Once the shelf is secure, lift the cart frame into an upright position.