Fence Adjustment - Black and Decker BDMS100 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

FENCE ADJUSTMENT

DISCONNECT MACHINE FROM POWER SOURCE!
In order that the saw can bevel to a full 47 degrees left, the left side of the fence can be adjusted to the left to provide clearance. To
adjust the fence, loosen the plastic knob shown in Figure 22 and slide the fence to the left. Make a dry run with the saw turned off and
check for clearance. Adjust the fence to be as close to the blade as practical to provide maximum workpiece support, without
interfering with arm up & down movement. Tighten knob securely. When the bevel operations are complete, don't forget to relocate the
fence to the right.
NOTE: The guide groove in the left side fence can become clogged with sawdust. If you notice that it is becoming clogged, use a stick
or some low pressure air to clear the guide groove.
Fig. 22
ADJUSTING THE DOWNWARD TRAVEL OF THE SAW BLADE
DISCONNECT MACHINE FROM POWER SOURCE!
1.
You can limit the downward travel of the saw blade to
prevent it from contacting any metal surfaces of the
machine. Make this adjustment by loosening the locknut
(A) Fig. 23 and turning the adjusting screw (B) in or out.
2.
Lower the blade as far as possible. Rotate the blade by
hand to make certain the teeth do not contact any metal
surfaces.
3.
Tighten the locknut (A)
All manuals and user guides at all-guides.com
14
B
A
Fig. 23

Publicidad

Tabla de contenido
loading

Tabla de contenido