Black and Decker BDMS100 Manual De Instrucciones página 17

GENERAL CUTTING OPERATIONS
1. Your machine has the capacity to cut standard 2 x 4's, lying flat or on edge, at the 45° right and left miter angles (Fig. A1 & A2).
2. A standard 2 x 6 can be cut in the 90° straight cut-off position in one pass (Fig. A3).
3. Cutting a standard 4 x 4 can be accomplished with one pass (Fig. A4).
4. This machine has the capacity to accurately cut crown mouldings and other bevel-type cuts (Fig. A5).
5. Cutting various sizes of plastic pipe is an easy job with this machine (Fig. A6). Hold pipe firmly against the fence. Use extra care
and secure pipe firmly when cutting angles into pipe.
A1
A3
A5
All manuals and user guides at all-guides.com
17
A2
A4
A6