Brush Inspection And Replacement - Black and Decker BDMS100 Manual De Instrucciones

BRUSH INSPECTION AND REPLACEMENT

Brush life varies. It depends on the load on the motor. Check the brushes after the first 50 hours of use for a new machine or after
a new set of brushes has been installed. After the first check, examine them after about 10 hours of use until a replacement is
necessary. To inspect the brushes:
DISCONNECT MACHINE FROM POWER SOURCE!
1. Remove three screws (A) Fig. 44 and remove the motor
cover (B).
2. The brushes are located in the two holders (C) Fig. 45.
Remove spade type terminal connector (D) and pull out
brush holders (C).
3. Fig. 46 illustrates one of the brushes (E) removed from the
holder (C). When the carbon on either brush (E) is worn to
3/16" in length or if either spring (F) or shunt wire is
burned or damaged in any way, replace both brushes. If
the brushes are found to be serviceable after re-moving,
reinstall them in the same position.
Fig. 45
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool; never immerse any part of the tool into a
liquid.
IMPORTANT
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (including brush inspection and replacement)
should be performed by authorized service centers or other qualified service organizations, always using identical replacement parts.
All manuals and user guides at all-guides.com
D
C
Fig. 44
F
E
Fig. 46
21
A
B
C