Tabla de contenido
Publicidad
For your own safety, please read and follow these instructions during the shed assembly.
1. Check your local building codes regarding footings, location, etc.
2. Select a site that allows enough working space around the shed.
3. Determine building foundation and anchor system.
4. Read and understand the Owner's manual enclosed in the package.
5. Follow all directions and dimensions thoroughly.
6. Follow the steps given in the manual carefully for correct assembly.
7. Make sure all parts are present before you start assembling.
8. BE SAFE : Follow safety instructions and avoid injury. (See inside page).
9. GROUND MUST BE EVEN : Make sure the foundation frame lies flat on the ground. If the earth bed is uneven, remove
10. Separate contents of the carton by the part number and review the list. Be sure you have all the necessary parts for your shed.
Refer to Owner's manual for part list
1. Always wear work gloves, long sleeves and eye protection during assembly of the shed. Some
pieces of the shed contain sharp edges and can cause injury.
2. Be cautious with the tools used for the assembly of the shed.
Familiarize yourself with the operation of all the power tools.
3.Children and pets should be kept away from the assembly site to avoid any
distractions and accidents.
4. When using a step ladder, make sure it is on even ground and
fully open with the safety latch in place. Never concentrate your full
weight on the roof or any part of the shed.
5. Do not attempt to assemble the shed on a windy day.
Shed panels can be whipped across by the wind making the
worksite difficult and dangerous.
Wear eye protection when using any form of power tools. Do not use voltage power tools in a wet or damp
environment to avoid electric shock.
Do not use any part of the shed as a means of personal support while attaching components during assembly.
The shed must be constructed on a solid base foundation. A concrete pad or large size concrete patio
stone squares is recommended for suitable floor base. Make sure it is firm and level and will allow drainage
away from the site. The base foundation should be at least 4 inches (100mm) larger than the shed dimensions.
Please refer to the front page of your owner's manual for the exterior dimensions of the shed. Manufacturer is
not responsible for the choice and construction of the foundation.
For a concrete pad base, prepare a level bed for a firm footing layer of crushed stone. The concrete pad
should then be poured to a thickness of 4 inches (100mm) to 5 inches (125mm). Allow to dry thoroughly
for at least 48 hours.
Your shed must be firmly anchored to the concrete pad or large concrete patio stone squares, to help protect
against damage in high winds.
Although this unit does not require any maintenance, care should be taken to prolong the life of your shed.It is for
one time assembling and set up, no purpose of re-using.
ROOF : Keep roof clean of leaves and snow with long handled, soft bristled broom. Heavy amounts
of snow on the roof can damage the shed making it unsafe. "Do not walk on roof surfaces! Risk of falling!".
WALLS : Do not rest any object against the wall panels of the shed.
DOORS : Keep doors closed to prevent wind damage.
FASTENERS : Regularly check your shed for loose screws, bolts, nuts, etc. and retighten them as necessary.
MOISTURE : With changing temperatures, condensation will accumulate inside the shed. Good
ventilation will help in regulating and avoid moisture.
TIP : A noncorrosive caulking is helpful to seal the shed
4
(EN) SAFETY & PRECAUTIONS
Before You Begin...
sod and other debris and level it with a flat shoval.
.
Safety First !
Care & Maintenance
DO NOT store Inflammable,Hazardous and Swimming pool chemicals in your
building.Combustibles and corrosives must be stored in air tight containers.
Enforce NO SMOKING.
Important
.
CAUTION
Sharp
Edges
Publicidad
Tabla de contenido
