Ariston CARES PREMIUM EXT Instrucciones Técnicas De Instalación Y Mantenimiento página 132

thermoregulation
GB
In the graph below, the curves have been
divided into two groups:
- low temperature systems
- high temperature systems
The two groups are divided based on
the different point of origin of the curves
for high-temperature systems, which
is +10°C, a correction which is usually
made to the fl ow temperature in this
type of system, during climatic adjust-
ment.
Turn the knob and select:
4.2.4 Room Infl uence Proportional
Press the OK button.
Turn the knob and set the most suitable
value, then press the OK button.
The infl uence of the room sensor can be
adjusted to a value between 20 (maxi-
mum infl uence) and 0 (no infl uence).
This means the contribution of the room
temperature to the fl ow temperature
calculation can be adjusted.
92
°C 100
90
80
70
60
50
40
30
10
Turn the knob and select:
4.2.5 Maximum temperature
Press the OK button.
Turn the knob and set the most suitable
value, then press the OK button.
Turn the knob and select:
4.2.6 Minimum temperature
Press the OK button.
Turn the knob and set the most suitable
value, then press the OK button.
4.2.9 Heat request mode
Turn the knob and select:
- Standard
- RT Time Programs Exclusion
- Forcing Heat Demand (Activation of
the function generates an always-on
heat demand)
Repeat the steps described to set the
values for zones 2 and 3, selecting men-
us 5 and 6.
3.5 3.0 2.5 2.0
5 0 -5 -10 -15
outdoor temperature
temperatura esterna
1.5
1.2
1.0
0.8
0.6
0.4
0.2
-20 °C
curve family chart