Whittier Wood Products 725W Hoja De Instrucciones página 4

FIG. 2
Read the instructions on how to operate CAM-LOCK SYSTEM on the enclosed sheet at this time.
2) Assemble the unit as shown in FIGURE 2. With the unit on its back, position the Bottom Shelf (D)
between the Side Panels (A & B) as shown and install and tighten Cam Housings (J). Place the
bottom shelf so the holes in the front edge are toward the front of the cabinet. Place the Top Shelf
(C[a]) so that the Cam Connectors (I) fit into the holes in the top edges of the side panels. Install the
cam housings and tighten. Tap the side panel until the shelf sits snug against it. Install the cam
housings in the bottom of the shelf and tighten securely.
ATTACHING THE CROWN MOULDING AND BASE:
3) Lay the Crown Moulding (E) face down on a cardboard or carpeted surface and screw Cam
Connectors (I) into the pre-drilled holes. See FIGURE 3. Position the crown moulding on the
cabinet and line up the Cam Connectors (I) with their corresponding holes in the Top Shelf. Install
and tighten the Cam Housings (J). See FIGURE 2.
Follow the same procedure for the Base (F).
Page 4 — 725W
All manuals and user guides at all-guides.com
C[a]
B
I
FIG. 3
TOP
E
D
BOTTOM
F
I
E
A