Whittier Wood Products 725W Hoja De Instrucciones página 5

FIG. 4
BOTTOM
A
4) Lay unit face down on a protected surface. Measure unit from left top to bottom right ( /
from right top to bottom left ( /
bottom of Side Panel (B) until measurements are equal. If line ( /
There is a hole drilled in the Back (G) to allow cord access if unit is to be used for stereo
components. Decide whether you would like the hole, higher or lower (hidden by an adjustable
shelf). Attach Back (G) to unit with #6 x 5/8" Flat Head Screws (K). Birch face of Back should face
toward inside of unit.
FIG. 5
5) Attach Corner Brace (O) to base and side panels 1/4" from bottom edge with #8 x 5/8" Pan
Head Screws (P). See FIGURE 5. Insert Adjustable Glides (N) into corner brace. Hammer Tack
Glides (M) into bottom of side panels about one inch from back edge.
All manuals and user guides at all-guides.com
K
D
). Measurements should be equal. If line ( /
M
G
B
M
Stain Test
Area
K
) is longer, tap
) is longer, tap Side Panel (A).
O
P
725W — Page 5
) and
N