Vortice MICROCOMFORT T Manual De Instrucciones página 26

ENGLISH
Note: After operation, the digital tube flashes for 30S. If there is no operation within 30S, the current settings
are saved and the heater enters weekly timing standby state; the operations of time period, start time, end time,
and digital tube flashing time of the thermostat temperature are also the same.
4) Press " " to display "P1" (program 1) on the digital tube and press it again to display "P2". You can set 2
EDID
programs a day: P1 and P2.
5) Press " " to set the start time, the digital tube displays "00". Press "
TIMEON
Note: The timer only allows setting the hour.
6) Press " " to set the stop time. The time is increased from the previous step. Press "
TIMEOFF
stop time.
Note 1: The stop time must always be delayed after the start time. If the two times are the same, the heater
enters standby mode.
Note 2: Default setting: week: d1; program section: P1; start time: 00 (00:00 pm); end time 00 (00:00 pm);
temperature: 25°C;
7) Press " / " to enter the thermostat temperature setting. For the setting method, refer to the third point
of the simple function section.
8) Finally, press " " to confirm the setting.
OK
9) Repeat steps 3 to 8 to set the start time and stop time of the weekly program. Up to 2 programs can be set
per day
Note 1: The temperature of the overlapping time period in the program runs according to the highest set
temperature, and it is performed in the order of the time period from 00:00 to 23:00. For example: 25°C from
4:00 to 7:00 and 30°C from 6:00 to 8:00, the operation mode is: Run at 25°C from 4:00 to 6:00 and run at 30°C
from 6:00 to 8:00.
Note 2: During weekly timing, the temperature and status indicators are not displayed if the clock time does not
reach the set time.
10) To turn off the weekly timing, press "
weekly program setting, and the heater returns to the original state.
Note 1: Changing the settings as described in the above steps will overwrite the previously set values. Press "
" to confirm the setting. Other buttons do not change the setting.
OK
Note 2: The weekly program setting is persistent, that is, it will return to the first day at the end of the seventh
day. If you don't want this, turn off the weekly timing.
Note 3: Look up settings. Press "
Note 4: " ", " ", "
DAY EDID
on.
26
" again, the weekly timing indicator disappears and leaves the
P
", " ", "
DAY EDID
TIMEON
"and " " are valid only when the weekly timing is turned on, that is, when "
TIMEON TIMEOFF
", " ", and the display will show the corresponding setting.
TIMEOFF
" to increase the start time (00-24).
TIMEON
" to increase the
TIMEOFF
" is
P