Test Procedure - Hach DR1300 FL Manual Del Usuario

Option
Update
Program
Factory
Default
Factory
Exit
Section 7 Do a test
Chemical or biological hazards. If this instrument is used to monitor
a treatment process and/or chemical feed system for which there
are regulatory limits and monitoring requirements related to public
health, public safety, food or beverage manufacture or processing,
it is the responsibility of the user of this instrument to know and
abide by any applicable regulation and to have sufficient and
appropriate mechanisms in place for compliance with applicable
regulations in the event of malfunction of the instrument.
Chemical exposure hazard. Obey laboratory safety procedures and
wear all of the personal protective equipment appropriate to the
chemicals that are handled. Refer to the current safety data sheets
(MSDS/SDS) for safety protocols.
Chemical exposure hazard. Dispose of chemicals and wastes in
accordance with local, regional and national regulations.
To do a test for a specific parameter (e.g., total chlorine), download the
test procedure from the manufacturer's website. Refer to

test procedure

The generic steps to do a test follow.
1. Push Enter to set the instrument to on. Keep the sample port cover
closed during startup.
2. Select TESTS, then select the parameter to measure.
14 English
Description
For Service use only
Sets the system settings back to the factory default
settings.
For Service use only
Goes back to the previous menu.
D A N G E R
C A U T I O N
C A U T I O N
on page 15.
Download a