Troubleshooting Check List - Simon, Evers & Co M-532962-PX001 Instrucciones De Manejo

Fig. 21
2. Be sure the load is centered on the unit.
WARNING!
If the load is off-center, it may shift when the
rotating ring is turned. You may be hurt or the
unit or load may be damaged.
UNLOADING WITH A FORK LIFT
1. Insert the forks fully into the pallet, and lift he
pallet straight up and clear of the top of the
unit. See Fig. 22.
 Raise the pallet until the springs on the unit
are fully extended.
 Be sure the pallet clears the top of the rotating
ring before you move the fork lift.
WARNING!
If you skip these steps, the unit may jump up
suddenly when you remove the pallet. You may
be hurt or the unit or load may be damaged.
F i g . 23
TROUBLESHOOTING

Troubleshooting Check List

Problem
The unit lowers too easily (too early).
The unit does not lower enough (too late).
The top of the unit rotates away from you.
The top of the unit bounces.
Excessive "rumble" when the ring rotates
MOVING THE UNIT
NOTICE
Do not move the unit while it is loaded. This
will damage the base frame of the unit. The
pockets on the base frame are designed to
support an unloaded unit, but cannot
support any extra weight.
1. Remove any load from the top of the unit.
2. Insert the forks into the pockets in the
base frame. See Fig. 23.
F i g . 22
Possible Cause
The spring combination may be too weak
for the load.
The spring combination may be too
strong for the load.
The frame of the unit may not be
level.
The shock absorber may be
damaged.
Wear or lack of lubrication to
bearings under rotating ring.
6
MAINTENANCE
Routine Periodic Maintenance every 90 days
 Check for loose hardware and signs of
excessive wear.
 Check to be sure that the unit is placed
on a firm level surface.
CheckThis
Check the spring ratings.
SeeTable 1.
Check the spring ratings.
SeeTable 1.
Move the unit to a level surface.
Contact Customer Service.
Contact Customer Service.