Stopping The Engine; Machine Usage - Garland CRUSHER 503 NRQG Manual De Instrucciones

English

6.4.2.3. STOPPING THE ENGINE

1. Place the throttle lever in positions, the minimum
speed and allow the engine to remain idle
seconds.
2. Set the switch to the "OFF" (stop) position.
3. Close the fuel tap.
6.4.3. CHECKPOINTS AFTER STARTING THE MACHINE
It is important to pay attention to the possible
individual parts or and the temperature of the
machine. If you detect any anomaly in the machine
immediately stop and check it carefully. In case of
any malfunction or problem take the machine to a
service technician to be repaired. In any case continue
to use the machine if the operation does not seem
appropriate.
Do not use the machine if it is damaged or
improperly adjusted.

7. MACHINE USAGE

Use this machine only for the uses for which it has
been designed. Using this machine for any other use
is dangerous and may cause damage to the user and/
or the machine.
Do not get close to the machine blades when they are
running.
Do not start the machine in a room or
enclosure.The exhaust gases and fuel and
oil vapors contain carbon monoxide and
harmful chemicals. In case of a concentration of gases
produced by poor ventilation, remove all that impedes
the flow of clean air to improve ventilation from the
work area and not return to work in the area unless
you have properly ventilated area and have clear that
ventilation is sufficient so that does not happen this
concentration again.
Work only in daylight or good artificial light. Do not use
this machine at night, in fog, or in poor visibility that
prevents you from clearly seeing the work area.
If you slip or fall, stop accelerating and move the
switch to the "OFF" position.
Do not use this machine if you are fatigued, ill, have
taken medication, drugs or alcohol.
Lack of rest and fatigue can lead to accidents or
damage.
Always set the machine on a flat and stable surface.
Do not use the machine on steep slopes where it
cannot guarantee your safety. If you work on slopes,
slow down your work and make sure you have good
stability.
Be alert when backing up or pulling the machine
toward you.
Do not rely solely on the safety devices on this
machine.
It is necessary to pay attention to possible loosening
or overheating of machine parts. If you detect any
abnormality, immediately stop the machine and check
it carefully. In case of failure, take the machine to the
technical service for repair. In no case should you
continue working if you notice that the operation is not
correct.
Remember to always use the machine with clean
hands and without traces of fuel or oil.
Clean the work area and remove all obstacles that
could cause accidents. Check the work area where
you will be working and remove all items that could
catch on the cutting tool. Also remove all objects that
44/172