Changing The Engine Oil - Garland CRUSHER 503 NRQG Manual De Instrucciones

English
8.2.1. OIL BATH FILTER
Attention: Only in engines with oil bath filter.
1. Remove the filter cover by unscrewing the wing nut
and washer.
2. Fill the base of the filter with clean SAE 10w/40
oil up to the "OIL LEVEL" mark or about 70 cm
failing that.
3. Install the air cleaner cover with washer and wing
nut.
WING NUT
WASHER
AIR FILTER COVER
ROUND FILTER
OIL TANK
AIR FILTER BASE
OIL LEVEL
Note: The engine should never be run without the
air filter installed.

8.2.2. CHANGING THE ENGINE OIL

Perform the oil change only while the engine is still
hot.
a pipeline network or on the Earth. The
of oil,
3
contamination of groundwater and water
tables is subject to heavy fines. There are special
collection places at service stations. If not, any
municipal authority will give you the relevant
information.
Note: You have two procedures at your disposition to
empty the engine oil. You can drain the oil
by loosening the drain screw (Y2) located at the base
of the filling canal or you can use the Garland engine
oil cleaner (ref.: 7199000020, not included with the
machine, which can be found at your nearest Garland
dealer) and suck the oil through the filling tube (Y1) of
the machine. For easy implementation, cleaning and
safety we recommend that you pick up the oil.
To change the oil:
- Place the machine on a flat, horizontal and
uncluttered surface.
Empty the engine oil:
- If it sucks the used oil: remove the engine oil plug
(Y1) and vacuum the motor oil by inserting the
Garland vacuum cleaner tube (REF.: 7199000020,
not included with machine) to the bottom.
- If you choose to empty the drain (Y2) through the
drain plug, please note the trajectory that the oil
will take into the chassis, place a large container to
48/172
WARNING! You must not throw old oil in
Y1
Y2