Tips For Use; Maintenance And Service - Garland CRUSHER 503 NRQG Manual De Instrucciones

the cutting tool can violently expel in the operation.
Do not allow anyone to enter the work perimeter. This
work perimeter must be 15 meters and is a dangerous
area.
Never leave this machine unattended.
Take care not to touch the hot parts of the
machine while the engine is running or after
use, such as the exhaust, the spark plug or
the high tension cables.
Do not use accessories on this machine other than
those recommended by our company, as their use
could cause severe damage to the user, people
around the machine and the machine itself.
Always follow the safety rules that we indicate in this
manual.
7.1. MACHINE SUPPORT AND GUIDANCE
While working always stand behind the machine and
hold it firmly with both hands on the handles.
Attention! Do not use the machine with one hand.
Attention!: The machine may bounce up or jump
forward unexpectedly if the teeth hit something hard
in the way such as large stones, roots or logs. Always
hold the machine firmly with both hands.
The blade lever on this machine is deactivated for
safety reasons. To activate the lever and transmit the
power of the motor to the blades, the blade activation
lever must be pressed.
GEAR CHANGE
This machine has three forward speeds and one
reverse speed. By activating the gear change lever you
can choose the one that best suits the work you are
going to do
7.2. WORK WITH THE MACHINE
Adjust the working depth using the height adjustment
(8).
Start the machine following the instructions in the
manual.
The moving wheels will pull the machine forward.
forward while maintaining the proper speed.
Go over the small bushes, weeds and brush that you
find along the way and the machine will clear them
as it goes.
When working on slopes, always position yourself a
little higher up the slope so that the machine is always
below you.

7.2.1. TIPS FOR USE

Place the machine on a stable surface free of weeds,
adjust the height lever (8) and place it in its highest
position in order to avoid possible materials that
may be placed under the machine. Before starting
to work, start the machine, adjust the accelerator (7)
and choose the gear (3) that best suits the work to be
done, then press the blade drive lever (1) and wait for
them to acquire their working speed, press the wheel
drive lever (2) and start working.

8. MAINTENANCE AND SERVICE

Perform regular inspections of the machine in order
to ensure efficient operation of the machine. For
complete service maintenance, we recommend to
take the machine to your service technician.
Before performing any maintenance or repair on
the machine make sure that the engine has
stopped and remove the spark plug pipe.
45/172
English