Led Indicator And Alarms - cecotec CONGA EXCELLENCE DRY Manual De Instrucciones

ENGLISH
Clean the charging pole: please use a dry cloth to clean the charging pole on the bottom of the
* Please take out the battery and keep it fittingly if the product is not to be used for a long time.
Once battery leakage is found, please remove the battery and clean the battery slot.
* This product uses a long-life battery and there is no need to change it a lot. If you need to change
the battery, please contact our after sales service or refer to method below to change the battery.
a. Remove the screw on the battery cover; take off the cover.
b. Pull out the plug between the cleaner and the battery, then take out the battery.
c. Insert the plug of the new battery and screw the battery cover.

5. LED INDICATOR AND ALARMS

LED indicator
Alarm reminder
When some failure happens to the cleaner, the button's red light blinks or stays on all the time,
at the same time the product emits a "beep" uneven in lenght. Please read the sheet below to find
out the failure reason:
Red light blinks::
Ref. Remind
nº Voice
01
02
03
04
Red light stays on all the time:
32 Conga Excellence Dry
05049_Conga Excellence Dry_Manual_SA.indd 32
cleaner and the charging base.
Master Status Indicated Status
Charging Blinking Green/Blue light
Charging finished Permanent Green/Blue light
Failure happen to Permanent or blinking Red light
master
Low battery Permanent Orange/Red light
Cleaning mode Permanent Green/Blue light
Failure Reason
the cleaner is han-
ging in the air or got
trapped
Infrared colli-
sion-avoiding
sensors abnormal
Cliff sensors ab-
normal
Other abnormalities The product's voltage is too low and it
Solution
Please move the cleaner to a new position
and restart it
Please check if the infrared collision-avoi-
ding sensors are stuck
Please check if the cliff sensors are dirty,
then clean them
needs manual help to charge
11/8/17 15:40