Dreame DreamBot W10 Manual página 13

Routine Maintenance
EN
Robot Sensors and Charging Contacts
Wipe sensors and charging contacts of the robot by using a soft, dry cloth:
· Cliff sensors at the bottom of the robot
· Charging contacts at the back of the robot
· Return-to-base sensor at the front of the robot
· Bumper at the front of the robot
· LDS on the top of the robot
Cliff Sensors
Bumper
Return-to-Base
Sensor
LDS
Charging Contacts
Note: Wet cloth can damage sensitive elements within the robot and base.
Please use dry cloth for cleaning.
20
Self-Wash Base Charging Contacts and Overflow
Sensor
Charging Contacts
Overflow Sensor
Robot Restarting
If the robot stops responding or cannot be turned off, press and hold down
the button for 10 seconds to forcefully turn it off. Then, press and hold the
button for 3 seconds to turn the robot on.
Battery
The robot contains a high-performance lithium-ion battery pack. Make sure
that the battery remains well-charged for daily use to maintain optimal
battery performance. If the robot is not used for an extended period of time,
turn it off and put it away. To prevent damages from over-discharging, charge
the robot at least once every three months.
Errors
If the base does not work properly, an error icon and message will be displayed on the display screen. Read the message and handle the issue based on the
following table.
Error Icon Error Message
Insufficient Water in Fresh Tank
Fresh Tank Not Installed
Waste Tank Malfunction
Washboard Not Installed
Abnormal Washboard Water Level
Robot Malfunction
Solution
Add a sufficient amount of water to the fresh tank.
Put the fresh tank in place.
Put the waste tank in place.
Empty the wastewater.
Check whether the washboard is installed and whether the clips on both sides of
the washboard are in place.
Check whether the waste port is clogged. If yes, clean it.
Check whether an exception occurs to the robot. Please refer to the "FAQ" section
in this manual for troubleshooting.
EN
21