Fein Slugger JME HoleMaker II Serie Instrucciones De Uso página 13

Assembly instructions.
Before mounting or replacing cutting tool or accessories, pull the power
WARNING
plug. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Mounting the spoke handle
(figure 2).
The hub assembly can be mounted on either
side.
Loosen the screw using a hex key.
Remove the spoke handle.
Mount the spoke handle on the other side
and tighten the screw using a hex key.
Fig. 2
1.
3.
en
13
2.
4.