Fein Slugger JME HoleMaker II Serie Instrucciones De Uso página 15

en
15
Filling the dismounted coolant container
Fig. 4
Upper closing cap
(figure 4)
Pull the empty coolant container out of the
2.
drill stand housing of the magnetic core drill.
Unscrew the cap from the coolant con-
tainer.
Fill in pump-feedable cooling lubricant, e.g.
1.
Slugger cutting oil.
Screw the cap onto the coolant container
again.
Insert the filled coolant container into the
holder on the drill stand housing intended
for this purpose.
3.
Coolant containe
4.
5.