Preparing Cappuccino; Setting The Quantity Of Coffee In A Cup - illy IPERESPRESSO X7.1 Manual De Instrucciones

- Insert the capsule holder in the brew head; turn the handle
to the right until it locks into place.
- Check that the coffee button
- Press and release the coffee button
brew the programmed quantity of coffee. To stop the fl ow in
advance, press the button again.
To make other coffees, remove the used capsule and repeat
the above steps.
Warning:
- The capsules are single-dose and cannot be used to
make two coffees.
- To ensure greater safety, the machine automatically
stops fl ow after approximately one minute.
- Remember to empty and clean the drip tray frequently.
SETTING THE QUANTITY OF
COFFEE IN A CUP
The X7.1 machine allows you to brew the desired quantity of
coffee in two modes: automatic and manual.
AUTOMATIC MODE - to set and memorise the quantity of cof-
fee to be brewed, carry out the following steps:
- Insert a capsule into the capsule holder and then fi t the latter
to the brew head.
- Place a cup beneath the capsule holder.
All manuals and user guides at all-guides.com
19
- Press the coffee button and keep it pressed until the coffee
MANUAL MODE
mode, carry out the following steps:
- Insert a capsule into the capsule holder and then fi t the latter
- Place a cup beneath the capsule holder.
- Press the coffee button and keep it pressed until the ma-
is lit.
Note: in the automatic mode it is also possible to make coffee
; the machine will
using the manual procedure.
- Press the coffee button for about 3 seconds;
- Press the coffee button again to stop the fl ow;
- In this manner you will not change the quantity of coffee
Note: when the machine is set for MANUAL MODE of the quan-
tity of coffee, after you start brewing it will be necessary to
press the coffee button again when the coffee has reached the
desired level in the cup in order to stop the fl ow.

PREPARING CAPPUCCINO

The machine features a steam wand for frothing the amount of
milk necessary to prepare one or more cappuccinos.
Prepare one or more cups of coffee following the instructions
in the previous section.
Froth the milk as follows:
has reached the desired level. Release the button. The ma-
chine is now programmed.
- to set the machine to work in the manual
to the brew head.
chine automatically stops dispensing coffee. Release the
button. In this case the programming has been cancelled.
initially programmed.
Press the steam button
steam icon in the central circle will
light up to signal that the machine
is getting ready to dispense steam.
EN
; the