Adjusting Trim Angle - Yamaha E8D Manual Del Propietário

8
q
9.9, 15
q
3-18
All manuals and user guides at all-guides.com

ADJUSTING TRIM ANGLE

EMU00951
Manual tilt model
There are 4 or 5 holes provided in the
clamp bracket to adjust the outboard motor
trim angle.
1) Stop the engine.
2) Remove the trim angle adjusting rod 1
001477
3) Reposition the rod in the desired hole.
To raise the bow ("trim-out"), move the rod
away from the transom.
To lower the bow ("trim-in"), move the rod
toward the transom.
Make test runs with the trim set to different
angles to find the position that works best
for your boat and operating conditions.
w
001478
8 Stop the engine before adjusting the
8 Use care to avoid being pinched when
8 Use caution when trying a trim posi-
NOTE:
The outboard motor trim angle can be
changed approximately 4 degrees by shift-
ing the trim adjusting-rod one hole.
from the clamp bracket while tilting the
motor up slightly.
trim angle.
removing or installing the rod.
tion for the first time. Increase speed
gradually and watch for any signs of
instability or control
Improper trim angle can cause loss of
control.
E
problems.