Bushnell PRIME L20 TRAIL CAMERA Manual De Instrucciones página 7

Inserting the SD Card
Insert the SD card (with the camera's power switch in the OFF position)
before beginning to operate the camera. Don't insert or remove the SD
card when the power switch is in the ON position.
The Prime L20 Trail Camera uses a standard SD (Secure Digital)
memory card to save photos (in .jpg format) and/or videos (in .avi
format). SD and SDHC (High Capacity) cards up to a maximum 32GB
capacity are supported. Before inserting the SD card into the card
slot after opening the camera's front cover, please make sure that the
write- protect switch on the side of the card is "off" (NOT in the "Lock"
position).
The following describes how to insert and remove the SD card:
• Insert the SD card into the card slot with its label side upwards (see
below). A "click" sound indicates that the card is installed successfully.
If the wrong side of the card is facing up, you will not be able to insert
it without force-there is only one correct way to insert cards. If the SD
card is not installed correctly, the device will not display an SD card icon
on the LCD in SETUP mode (the SD card icon displayed after switching
to SETUP mode will have a "lock" symbol inside it in it if the card is
locked). Formatting the SD card by using the Prime L20 Trail Camera
"Format" parameter before using it for the first time is recommended,
especially when a card has been used in other devices (see "Changing
Menu Parameter Settings" for details).
• To take out the SD card, just gently push
in the card (do not try to pull it out without
pushing in first). The card is released from
the slot and ready to be removed when you
hear the click. Be sure the camera's power is
switched OFF before inserting or removing
SD cards or batteries.
7