Sauder 423974 Manual Del Usuario página 9

Step 5
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the enlarged diagram below. Be
å
prepared, the parts are greasy.
Fasten the EXTENSION RAILS (1) to the EXTENSION BLOCKS (G) on the ENDS (A and B). Use four BLACK 1/2" FLAT
å
HEAD SCREWS (24).
NOTE: For each EXTENSION RAIL, turn a SCREW into the back hole. Then, slide the inner cartridge of the
å
EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the EXTENSION BLOCK. Turn a SCREW into
this hole.
NOTE: The EXTENSION SLIDES will be used later for the LARGE DRAWER.
å
BLACK 1/2" FLAT HEAD SCREW
(4 used in this step)
Open end
1
Push up on the black lever and pull the SLIDE from the RAIL.
1
Use these holes.
24
1
G
Open end
B
2
1
G
A
Open end
Page 9