Thermador Professional Pro Grand Serie Manual De Instalación página 19

3. Flip the hinge clips for both sides of the door. A
screwdriver may be required to carefully pry the clip.
4. Close the door gently until it stops against the hinge
clips. The open hinge clips will hold the door open at
a slight angle, about 30°, from the closed position.
5. Grasp the door firmly on the ends of the door. Lift the
door up and out. There will be some spring resistance
to overcome.
6. Place the door in a safe and stable location.
To reinstall the oven door
1. Hold the door firmly in both hands.
2. Hold the door at a 30° angle from the closed position.
Insert hinges centered evenly into the hinge slots. The
hinges will securely hook into the slots when properly
installed. DO NOT force, bend or twist the door.
3. Open door fully to expose hinges, levers, and slots.
4. Flip the hinge until seated on the bracket. A
screwdriver may be required to carefully push the clip.
5. Close and open the door slowly to ensure it is
correctly and securely in place.
To check door fit and adjustment
1. Open and close the door slowly to test the movement
and the fit of the door to the oven cavity. DO NOT
force the door to open or close. If the door is properly
installed, it should move smoothly and rest straight on
the front of the range when closed.
2. The range must be level for proper alignment of the
oven doors, see "Placing and leveling the range".
3. Verify that the hinges are properly seated into the
hinge slots, and that the hinge clips are fully engaged
into the slots.
If door or handle appears slightly tilted
4. Rotate the large star-head screw located directly
above the hinge receiver with a T-30 star-head driver.
Rotate each screw respective to its side and direction
the door needs to be adjusted.
NOTE: The steam oven door is not adjustable.
To remove the warming drawer
1. On the top of the warming drawer door, remove the
three (3) T-20 screws.
18