Indicator Lamp "Ready For Use" Turns Off - Kärcher HDS 995 M Eco Manual De Instrucciones

Clean sieve in the water shortage safe
guard.
Display
Troubleshotting
Replace the reed switch of the water
shortage safeguard (Customer Serv-
ice).
Clean the water shortage safeguard
(Customer Service).
Display
Troubleshotting
Remove leaks in the high pressure sys-
tem.
Display
Troubleshotting
– Engine overload/overheat
Turn device switch on "0" and let engine
cool off for min. 5 minutes.
If malfunction still occurs, have device
checked by customer service.
Figure 17
Check exhaust temperature limiter; re-
duce it, if required.
Display
Troubleshotting
– This error code is displayed only for ap-
pliances with the flame monitoring at-
tachment.
– See Assembly Instructions of Flame
monitoring attachment.
Indicator lamp "Ready for use"
turns off
Figure 2 - Pos. 8
– Engine overload/overheat
All manuals and user guides at all-guides.com
Figure 2 - Pos. 3
– Fuel tank empty
Indicator lamp liquid softener glows
Figure 2 - Pos. 4
– Liquid softener tank is empty, due to
– Electrodes in the tank are dirty
Indicator lamp for detergent glows
Figure 2 - Pos. 5+6
– Detergent tank is empty.
– No power
Device is not building up pressure
– Air within the system
Vent pump:
Turn device switch on "0" and let engine
cool off for min. 5 minutes.
If malfunction still occurs, have device
checked by customer service.
No line voltage, see "Appliance is not
running".
Fuel indicator lamp glows
Refill.
technical reasons a remainder stays in
the tank.
Refill.
Clean the electrodes.
Refill.
Appliance is not running
Check power connection/conduit.
Set dosing value for detergent to "0".
With open hand spray gun turn device
on and off multiple times with the device
switch.
Close and open the regulating spingle
(figure 9) with open hand spray gun.
31
English