Error Code - GYS POT COMBI ARCPULL Manual De Instrucciones

Operating manual
The cover must be placed on the other side of the pusher pad.
The gas-shielding cover must not be fitted to the earthing pad when welding without a gas shield.
• Position the pad (equipped with its cover) to the end of the earthing
rods and then screw in the two clamping screws. We recommend posi-
tioning the pad with the clamping screws facing the bottom of the gun
to keep the positioning markings clearly visible.
Note: Using the gas protection and earthing pad is not necessary when
welding a pulling ring.
ERROR MESSAGE, ANOMALIES, CAUSES AND SOLUTIONS
This equipment has a fault monitoring system. An error message will be shown on the display screen in the event of a
fault.

Error code

Thermally protecting
DEFAUT THERMIQUE
Mains voltage fault
DEFAUT SECTEUR
TOUCHE APPUYEE
Gun communication
DEFAUT COM.
The gun's thermal
DEFAUT THERMIQUE
DEFAUT MOTEUR
Note: any intervention that requires opening up the product and checking the electrical system must be carried out by
a qualified technician.
Translation of the original
instructions
Meaning
Exceeding the duty cycle.
the machine
Mains voltage out of range
or missing a phase.
A key on the keypad has
Keypad fault been pressed when the
product is switched on.
The communication
between the gun and the
fault machine is not functio-
Exceeding the duty cycle.
protection.
The gun's mechanism is
Gun motor fault.
Positioning
markings
clamping screw
Causes
Wait until the message has disappeared
Have your electrical system checked by an
authorised person. The voltage between
phase and neutral must be between 200 -
265 VAC for a 230 VAC network.
Have the keypad checked by a qualified
Reconnect the gun and turn the welding
machine off and on again. If the fault
persists, have the product checked by a
ning.
Wait until the message has disappeared
Reconnect the gun and turn the welding
machine off and on again. If the fault per-
blocked. sists, have the gun checked by a qualified
GYSPOT COMBI ARCPULL
Solutions
before resuming welding.
person.
qualified technician.
before resuming welding.
technician.
33