GYS POT COMBI ARCPULL Manual De Instrucciones página 35

Operating manual
Power level
Sheet metal thickness
(mm)
- To change the weld time, press the arrows (7). - (only accessible in MANUAL mode).
Weld time (ms)
5. Use button (6) to select the ignition type (see ignition section):
- indicator light (4) (
- indicator light (5) (
6. Carry out the welding according to the operating instructions.
7. After its first use, the steel section will light up every time the machine is switched on (using the settings from the
most recently completed welding point). It also records the settings for each individual welding gun and tool used
for the last completed weld.
OPERATING INSTRUCTIONS
Operating the Device
Proceed as follows:
1. Connect the welding unit's earth clamp to the sheet metal that needs to be straightened out following the advice
below:
- place it on the point closest to the area to be worked on
- do not connect it to a nearby workpiece (For example: do not connect the earth connection to a door in order to
straighten out the vehicle's wing)
- strip the sheet metal neatly at the connection point
2. Strip the area where the sheet metal is going to be worked.
3. Place one of the tools provided onto the end of the welding gun, firmly tightening the nut onto the end of the gun.
4. Select the tool and the power level.
5. Bring the welding gun tool into contact with the sheet metal to be welded.
6. Carry out your weld.
Ignition
This device is equipped with two ignition systems:
MANUAL mode (trigger operated)
1. Connect the power-supply connector to the control connector,
2. Press the ignition selection button (6) until the LED (4-
The automatic mode will no longer work at this point, only direct pressure on the trigger will produce a weld.
AUTOMATIC mode
1. Connect the power connector,
2. Press the ignition selection button (6) until the LED (5 -
The unit is equipped with an automatic, welding ignition system.
The machine will automatically detect the electrical contact and will produce a weld point in less than one second. To
create a welding point, break the contact between the tip of the welding gun and the workpiece for at least half
second
a second and then make contact again.
For optimum performance, we recommend that you use the original earthing cable and guns
supplied with the machine.
Translation of the original
instructions
L 1 2
0.6 0.7 0.8
L 1 2
10 20 30
) signals that a trigger gun is being used
) signals that an automatic gun is being used
3 4 5 6
0.9 1.0 1.1 1.2
3 4 5 6
40 50 80 100
(option: PN. 050679)
) lights up (FIG-II p.2).
) lights up (FIG-II p.2).
GYSPOT COMBI ARCPULL
7 8 9 H
1.3 1.4 1.5 1.6
7 8 9 H
200 300 400 500
.
35