Safety Functions - Teka HLB 85-G1 P BM Manual Del Usuario

Safety functions

CHILD SAFETY LOCK
This function can be selected at any time while
using the oven.
To activate the function, press and hold
you hear one beep and symbol
on the screen. The clock/timer is locked.
If the oven is off and you activate the child safety
function, the oven will not work even if a cooking
function is selected.
If this function is activated while you are cook-
ing, it will only lock the electronic clock/timer
settings.
To activate the function, press and hold
you hear one beep.
MANUAL DOOR LOCK
Available in pyrolytic models only.
This function allows the oven door to be locked.
IMPORTANT
This function can only be selected when the
oven control dial is in the rest position
Once the door is locked, you can start cook-
ing normally.
To activate/deactivate the door lock, proceed as
follows:
1. Press or
Teka Hydroclean
This function is used to clean the grease and
dirt on the walls of the oven. To make it easier
to clean the oven, do not allow dirt to build up.
Clean the oven often.
142 User Guide
is displayed
until symbol flashes on
®
function
the screen. The current state of the door
lock is displayed. "On" if the lock is active
and "Off" if it is deactivated.
until
2. Press
starts to close if it was «Off» and to open if
it was «On».
WARNING
Before turning on the lock, check that the
oven door is correctly closed. If the door is
not correctly closed, it will not lock and an
alarm is heard. if this happens, switch off
until
the alarm by pressing any key on the clock,
close the door correctly and activate the lock
again, following the instructions above.
3. Once the door has been completely locked/
unlocked, the new state of the door is dis-
played on the screen. If the lock is on, sym-
bol remains lit on the screen.
.
IMPORTANT
To unlock the door while cooking, turn the
control dial to rest
following the instructions above. When the
door is unlocked, turn the control dial to the
previous position to continue cooking.
PROGRAM THE TEKA HYDROCLEAN®
FUNCTION
WARNING
Do not pour water inside the hot oven. This
could damage the enamel on the oven.
Always run the cycle when the oven is cold. If
the oven is too hot, the results may be affected
and the enamel damaged.
First remove the trays and all the accessories
from inside the oven, including the supports for
the trays or telescopic guides. Follow the in-
. A beep is heard and the lock
and unlock the door