Led Indication; Using Your Robovac; Important Tips Before Use - EUFY RoboVac G20 Manual Del Usuario

LED Indication

You can see the status of RoboVac from the LED indicators.
(Power Status Light)
Status
Pulsing orange Charging
Solid blue Standby / Cleaning / Fully charged
Solid orange Low power and returning to Charging Base
• RoboVac is off.
• To conserve power, the light automatically turns off
Off
when RoboVac is not docked to the Charging Base
and has been inactive for 10 minutes.
RoboVac has an error.
Flashing red & Voice alert
Refer to the "Troubleshooting>Voice Alert" section in
this manual for solutions.
(Wi-Fi Status Light) Status
Slowly flashing blue Waiting for connection
Rapidly flashing blue Connecting with your wireless router
Solid blue Connected to your wireless router
18 EN

Using Your RoboVac

Important Tips Before Use

A B
D E
Remove power cords and small objects from the floor that may entangle RoboVac.
Use the supplied cable ties to organize your wires and power cords.
Fold tasseled edges of area rugs underneath to prevent tangling RoboVac. Avoid
cleaning very dark-colored high-pile rugs or rugs thicker than 1.02 in/26 mm as
they may cause RoboVac to malfunction.
It is strongly recommended to place boundary strips (sold separately) in front of
fireplaces and certain areas (i.e. air vents) that may cause damage to RoboVac if
entered.
Keep RoboVac away from wet areas during cleaning.
RoboVac may climb on top of objects less than 0.67 in/17 mm in height. Remove
these objects if possible.
Anti-drop sensors will prevent RoboVac from tumbling downstairs and steep drops
in most cases. Sensors are less effective if dirty or used on carpeted/reflective/very
dark-colored floors. It is recommended to place physical barriers to block off areas
where RoboVac may fall.
C
F
EN 19