Preparation - EUFY RoboVac G20 Manual Del Usuario

Preparation

1
Remove the foam blocks beside the bumper before use.
2
Install the side brush before use.
3
Turn on the main power switch on the bottom of RoboVac.
OFF
ON
20 EN
4
Place the Charging Base on a level surface and against a wall.
5 Remove objects within 3 ft / 1 m of the left and right side and within 6 ft / 2 m of
the front of the Charging Base. If you cannot remove the objects, move RoboVac
to a new place and check whether RoboVac can return to the Charging Base
normally; if not, contact eufy customer service for help.
6 Connect the adapter to the Charging Base and a wall outlet.
• When the Charging Base connects to AC power, the LED indicator on the
Charging Base is SOLID WHITE.
• Install the Charging Base in a location that RoboVac can easily access. It is
recommended to place the Charging Base against a wall, and on a hard-level
surface rather than on rugs or carpets.
• Always keep the Charging Base plugged in, otherwise RoboVac will not
automatically return to it.
EN 21