Checking And Cleaning The Drive Sprocket; Idling Speed Setting; Help In Case Of Malfunction; Transport - AL-KO solo MT 130 Manual De Instrucciones

Help in case of malfunction

7.2 Checking and cleaning the drive
sprocket
The load on the drive sprocket (05/2) is particu-
larly intense. Therefore, perform the following
tasks:
1. Check the teeth of the drive sprocket regular-
ly for wear or damage.
2. Clean the drive sprocket and guide rail at-
tachment with a brush.
NOTE A worn or damaged drive sprocket re-
duces the service life of the saw chain, and so
the drive sprocket should be renewed without de-
lay by the customer service.
7.3

Idling speed setting

The cutting tool is not allowed to move when the
engine is idling. If the cutting tool does move
Malfunction
The chain bar and saw chain
become hot when running.
Smoke development.
Motor running, but the saw
chain does not move.
Only sawdust is thrown out,
rather than wood chips. The
pole-mounted pruner must
be forced through the wood.
Appliance vibrates unusual-
ly.
Further malfunctions

9 TRANSPORT

Perform the following measures before transport-
ing the appliance:
1. Switch off the appliance.
2. Separate basic appliance, shaft extension (if
used) and attachment from one another.
3. Secure and transport the appliance upright
so that saw chain oil does not run out.
443445_a
when the engine is idling, you must consult your
dealer in order to achieve the correct engine set-
ting.
8 HELP IN CASE OF MALFUNCTION
and moving appliance parts can lead to injury.
■
this table or that you cannot resolve yourself,
please contact our customer service.
Cause
The saw chain is too taut.
Oil tank is empty.
The oil entry hole and/or
groove of the chain bar are
dirty.
The saw chain is too taut.
Appliance fault
The saw chain is blunt.
Appliance fault
See "Multitool MT 130 – basic appliance" operating instructions.

10 STORAGE

Thoroughly clean the appliance after each use
and – if present – attach all covers. Store the ap-
pliance in a dry, lockable place out of the reach of
children.
Carry out the following jobs before intervals in
work lasting for longer than 30 days:
1. Empty the oil tank for the saw chain oil.
2. Remove the saw chain and guide rail, clean it
CAUTION! Risk of injury. Sharp-edged
Always wear protective gloves during mainte-
nance, care and cleaning work!
NOTE For malfunctions that are not listed in
Remedy
Check the chain tension. Retension
the saw chain.
Refill with saw chain oil.
Clean the oil entry hole and groove
of the chain bar.
Check the chain tension. Retension
the saw chain.
Contact one of the manufacturer's
service centres.
Sharpen the saw chain or contact
one of the manufacturer's service
centres.
Contact one of the manufacturer's
service centres.
and spray it with rust-proofing oil.
23