MIRKA Motor Drive Cabinet Instrucciones De Manejo página 23

en (original)
Indicator
D36
Speed set-point display
RPM BIT 8
D22
4,000 -
5,000 -
6,000 -
7,000 -
8,000 -
9,000 -
10,000 -
Modbus RTU slave address display
BIT 8 BIT 7
D22 D21
Jumper description
Jumpers
JP1
JP2
JP3
JP4
JP12
JP13
JP15
Tool cable connector pinout
Pin (colour, size)
PE (green–yellow,
1.0 mm2)
1 (brown, 1.00 mm²)
2 (blue, 1.00 mm²)
3 (black, 1.00 mm²)
A (grey, 0.25 mm²)
B (pink, 0.25 mm²)
C (green, 0.25 mm²)
C (yellow, 0.25 mm²)
D (brown, 0.25 mm²)
E (white, 0.25 mm²)
NOTE! NTC– and P– are connected together to the same PIN inside the connector.
Description
Possible tool wiring fault. Turns red when a possible fault in tool C+/C–/P+/P– wiring is detected.
BIT 7 BIT 6
D21 D20
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF ON
ON ON
BIT 6 BIT 5
D20 D19
Default
Not set
Not set
Not set
Not set
Not set
Not set
Not set
Description
Not in use
Phase A
Phase B
Phase C
C-
C+
P–
NTC–
NTC+
P+
BIT 5 BIT 4
D19 D18
OFF OFF
OFF OFF
OFF OFF
OFF ON
ON ON
ON ON
ON ON
BIT 4 BIT 3
D18 D17
Description
Reserved for future use
If set, a terminating resistor of 270 Ω is connec-
ted across Modbus RTU pins A and B.
If set, a pull-down resistor of 10 kΩ is connec-
ted to Modbus RTU B-pin.
If set, a pull-up resistor of 10 kΩ is connected
to Modbus RTU A-pin.
If set, digital speed control feature is enabled.
If set, D2–D3, D17–D22 indicators will output
the current Modbus RTU slave address instead
of speed set-point.
Reset to factory settings.
BIT 3 BIT 2
D17 D3
OFF OFF
OFF ON
ON ON
ON ON
ON ON
ON ON
ON ON
BIT 2 BIT 1
D3 D2
Mirka® Motor Drive Cabinet
BIT 1
D2
ON
ON
ON
ON
ON
ON
ON
23