Before Startup; Operation - Kärcher BRS 43/500 C Manual De Instrucciones

Before Startup

Installing the Brushes
 Place the slider vertically and arrest.
 Tilt the appliance backward and store it
on the pushing handle.
 Place the brush roller onto the driver
and lock into place on the opposite side.

Operation

DANGER
Danger of injury by electric shock.
Check the mains cables of the machine
each time before using the machine to see
that it is not damaged. Never operate a ma-
chine with damaged cables. Get the dam-
aged cables replaced by an electrician.
Risk of injury on account of electric shock
caused by a damaged mains cable. Do not
let the mains cable come in contact with the
rotating brushes or pads.
NOTICE
To put the brush drive out of operation imme-
diately, move the appliance switch to "0".
Drive the machine
 Place the slider vertically and arrest.
 Tilt the appliance toward the back and
drive it to the place of use on its trans-
port wheels.
Filling in detergents
CAUTION
Risk of damage. Only use the recommend-
ed detergents. With respect to different de-
tergents the operator bears the increased
risk regarding the operational safety, acci-
dent risk and reduced product life of the ap-
pliance. Only use detergents that are free
from solvents, hydrochloric acid and hydro-
fluoric acid.
Follow the safety instructions for using de-
tergents.
Do not process any inflammable, explo-
sive, corrosive or poisonous consumables.
NOTICE
Observe the dosing notes.
Recommended detergents:
12
Application
Intermediate carpet
cleaning
Dosage 6%:
Fill quantity water [li-
tres]
1
2
3
4
5
6
7
Removing the detergent tank
To fill the detergent tank at a sink, the de-
tergent tank can be removed from the appli-
ance as follows:
 Squeeze the detergent hose and pull it
off the tank.
 Unhook both upper ends of the deter-
gent tank support from the appliance.
 Lift off the detergent tank.
Fill detergent tank
 Open the lid of the detergent tank.
 Fill the detergent tank with water and
leave sufficient room for the detergent.
 Dose the detergent according to the
provided product information.
 Close the lid of the detergent tank.
 Reattach the detergent tank to the ap-
pliance if necessary.
 Vacuum loose dirt with a vacuum clean-
er prior to cleaning.
 Remove the nozzle from the nozzle
holder and screw it into the detergent
solution outlet.
 Insert the mains plug into the socket.
 Activate the lock of the slider and turn it
to the back with your foot.
 Set the appliance switch to "I".
 Press the brush drive button - the
brushes will begin to rotate.
 Press the detergent button - the deter-
gent will be applied as long as the but-
ton is pressed.
 Move the appliance over the surface to
be processed by the slider.
– 3
EN
Detergent
RM 768 iCapsol
Fill quantity of deter-
gent – 768 [ml]
60
120
180
240
300
360
420
Cleaning