Environmental Protection; Control Elements; During First Start-Up - Kärcher BRS 43/500 C Manual De Instrucciones

Environmental protection

The packaging materials are re-
cyclable. Please do not throw
packaging in the domestic waste
but pass it on for recycling.
Old units contain valuable recy-
clable materials. Batteries, oil
and similar substances may not
be released into the environ-
ment. Therefore please dispose
of old units through suitable col-
lection systems.
Notes about the ingredients (REACH)
You will find current information about the
ingredients at:
www.kaercher.com/REACH

Control elements

1 Power switch
2 Key detergent solution
3 Push handle
4 Brush drive button
5 Cable clamp
6 Detergent Tank
7 Spray bottle holder
8 Lock of pushing handle
9 Button for brush change
10 Waste container
11 Sieve
12 Detergent solution outlet
13 Brushing rollers
14 Overload fuse for brush drive
15 Detergent tank support
16 Detergent tank lid
17 Detergent hose coupling
18 Nozzle, made available in delivery con-
dition
19 Nozzle holder

During first start-up

Figure 1, see cover page
 Remove the appliance and the push
handle from the packaging and assem-
ble as shown in the illustration.
Figure 2, see cover page
 Connect a cable between the appliance
and the push handle.
 Slide the connector into the push han-
dle.
Figure 3, see cover page
 When inserting the push handle into the
appliance, adjust the cable through the
slot in the push handle so that it is not
pinched.
Figure 4, see cover page
 Slide the push handle all the way onto
the appliance.
 Thread in the 4 included screws and
tighten them.
 Fill water into the detergent tank.
 Insert the mains plug into the socket.
 Set the appliance switch to "I".
 Press and hold the key for the detergent
solution and flush the water system.
 Set the appliance switch to "0".
 Disconnect the main plug from the
socket.
– 2
EN 11