Start Up - Truper TPN-734H-2 Manual

Air Outlet Connection
CAUTION • We recommend using fast couple hoses to easily get them
connected to the included nipple. This way it can be connected and
disconnected tools fast and interchange easily.
• Remove the plastic cap covering the air inlet in the handle base.
• Screw the included nipple to the air inlet
• Connect the air hose via the quick-connect nipple.
Rotation Direction and Torque Selection
• The rotation direction gets adjusted with the rotation selector.
• To tighten a nut or lug, push the rotation selector and turn clockwise. To
loosen, push the rotation selector and turn counterclockwise.
• To select torque and prevent from applying too much force to a nut or lug,
turn the torque selector up to the desired level according to the lower table.
To adjust torque to tighten use the Allen key. To loosen torque use a flat
screwdriver.
• We recommend using maximum torque in the event of not having a torque
meter to verify the right torque.
• Torque value may vary depending of the air compressor size and the
amount of cubic feet of air (CFM) it delivers.
Turning ON
• Turn the air compressor ON and allow it to get filled.
• Regulate the air compressor outlet pressure to 90 PSI to 110 PSI.
WARNING • The tool operates with this pressure range. If
operating in a higher pressure range the tool useful life will be
shorter.
• Let run some air through the hose and coupling to verify both
are clean before connecting into the tool.
• Select the adequate rotation direction and torque.
• Press the trigger so that the die can rotate.
• Release the trigger to stop the die.
Operation
• Set the die in the nut or lug you want to loosen or tighten.
• Do not try to make contact with the nut or lug with the die moving. Do not press the
trigger unless the nut or lug is set correctly inside the die.
• Apply firm and constant pressure without forcing the tool. Otherwise it can be damaged.
8
ENGLISH

Start Up

Air Inlet
Nipple
Stopper to secure
the fast couple
into the air hose
Rotation Selector on the
Tightening Position
Torque Selector in
the Loosening
Position
Trigger
Plastic
Cap
Torque Selector in
the Tightening
Position