Start Up - Truper TPN-883-2 Manual

Start Up

Air Inlet Connection
• Connect the air hose to the tool with the adapters (not
included), fixing the female connector to the air inlet
connection.
• If using various pneumatic tools and only one compressor, a
fast coupling (not included) is recommended, together with the
adapter, to quickly connect and disconnect the tools and
interchange them easily.
Lubrication
• Use an air line lubricant with SAE oil No. 10, set to two
drops per minute. If an airline lubricant cannot be used,
apply pneumatic engine oil to the entrance hole once a
day.
• Put a drop of tool lubricant in the jaws every 5,000 cycles.
Turning ON
• Let some air run down the hose and the cople to verify
that both are clean before connecting them to the tool
• Plug the tool into the air line.
• Turn ON the air compressor until is full.
• Regulate the compressor air outlet pressure, from 80 PSI,
up to 100 PSI.
WARNING
The tool operates in the pressure range
mentioned above. If operating in a higher range, the service
life of the machine will be shorter.
Operation
• Insert the rivet stem in the river nozzle.
• To hold the rivet in any position, see the section
"Vacuum System".
• Find the orifice to put the rivet into and insert the rivet
head in it.
• Hold firmly the riveter and press the trigger.
• Release the trigger and remove the riveter.
Vacuum System Adjustment
• To activate the vacuum system, turn the adjusting knob
counterclockwise until getting the desired rivet fastening.
NOTE When activating the vacuum system, the air
pressure lowers, therefore the working pressure needs
adjusting. See the "Turning ON" section.
WARNING When not operating in the pressure
range established, the riveter cannot separate the stem
from the rivet.
• To deactivate the vacuum system, turn the adjusting
knob clockwise.
Female
connector Fast cople
Trigger
Air Inlet
Connection
Air Hose
7
ENGLISH