Tabla de contenido
Publicidad
Air Outlet Connection
• Remove the plastic capo (A) covering the air inlet in the
handle base.
• Before each use add three to six drops of lubricant with
no detergent (B) into the air inlet (C).
• Screw the quick connector (D) (not included) to the air
inlet.
• Connect the air hose using a fast nipple (E), (not
included) into the quick connector.
Rotation Direction and Torque Selection
• Rotation direction is adjusted with the torque selector (F).
• To tighten a nut or lug, turn the selector to the right so
that the die rotate on clockwise. To loosen turn the knob to
the left to make the die rotate counter clockwise.
• To select torque and prevent from tightening too much, a
nut or lug, turn the knob to the right or to the left until
reaching the desired torque level.
• Using the maximum torque is recommended when there
is no torque meter to verify the adequate torque.
• The torque value may vary depending on the air
compressor size and the quantity of air (CFM) it delivers.
Turning On
• Turn ON the air compressor and let it fill up.
• Regulate the air compressor outlet pressure to 90 PSI.
WARNING
The tool operates with this pressure
range. If operating in a higher pressure range the tool
useful life will be shorter.
• Let run some air through the hose and coupling to
verify both are clean before connecting into the tool.
• Select the adequate rotation direction and torque.
• Press the trigger so that the die can rotate.
• Release the trigger to stop the die.
Operation
• Set the die in the nut or lug you want to loosen or
tighten.
• Before operating the tool double check there is enough
space in the back of the tool to prevent getting your hand
trapped. The tool goes away from the nut / screw when
loosened or tightened.
• Do not try to make contact with the nut or lug with the
die moving. Do not press the trigger unless the nut or lug
is set correctly inside the die.
• Apply firm and constant pressure without forcing the
tool. Otherwise it can be damaged.
8
ENGLISH
Start Up
D
B
C
F
Trigger
E
A
Publicidad
Tabla de contenido
