Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Start Up
• The heat gun is used to weld plastics (joints, patches, vulcanization of canvas, etc.), to remove decals and adhesive, loosen
oxidized or tight metal nuts, to soften old mastic to remove it and setting new, removing paint, thaw metal pipes, apply
anti-theft film in automotive glass, drying paint, varnish, wet wood, etc., to set PVC shrinkable packaging covers, to remove
dents from automotive fascia's, remove adhesive floor covering, etc.
Turning on and Operation Control
• Connect the plug to the power supply.
• Move the switch into one of the two positions.,
depending on the air temperature needed for the job.
Position 2 offers higher temperature than position 1.
Nozzles Set Up
(not included)
• The nozzles are set using pressure as far as it goes in the
air inlet.
CAUTION
• Wait until the air inlet cools down
completely before setting or replacing a nozzle.
• Depending on the shape the different nozzles
concentrate and spread heat differently, applying different
amounts of heat necessary for the job.
7
ENGLISH
Publicidad
Tabla de contenido
