Porter Cable CPLC7060V Manual De Instrucciones página 9

TOOLS REqUIRED FOR
ASSEMBLY
1 - 9/16" socket or open end wrench
1 - Electric Drill
UNPACkING
1. Remove all packaging.
It may be necessary to
brace or support one side of the outfit
when removing the pallet because the
air compressor will have a tendency
to tip.
LOCATION OF THE AIR
COMPRESSOR
• Locate the air compressor in a
clean, dry, and well ventilated
area.
• Located the air compressor at
least 12" (30.5 cm) away from the
wall or other obstructions that will
interfere with the flow of air.
• Locate the air compressor as
close to the main power supply
as possible to avoid using long
lengths of electrical wiring. NOTE:
Long lengths of electrical wiring
could cause power loss to the
motor.
• The air filter must be kept clear of
obstructions which could reduce
air flow to the air compressor.
ANCHORING OF THE AIR
COMPRESSOR
Risk of
Excessive vibration can weaken the
air tank and cause an explosion.
The compressor must be properly
mounted.
The air compressor MUST be bolted to
a solid, level surface.
Hardware needed:
4 - Concrete anchors
(not supplied)
4 - 3/8" Lag screw to fit concrete
anchors (not supplied)
4 ­ 5/8" Washer
(found in parts bag)
- shims (if needed)
All manuals and user guides at all-guides.com
ASSEMBLY
2. Remove and discard the (4) screws
and washers holding the compres-
sor to the pallet.
3. With the help of another person
carefully remove air compressor
from pallet and place on a level
surface.
shipped with oil in the pump crank-
case. Check oil before operating air
compressor, see Check Oil under
Maintenance.
INSTALLATION
1. Place the air compressor on on a
solid, level surface.
2. Mark the surface using the holes
in the air compressor feet as a
template.
3. Drill holes in the surface for the
concrete anchors. Install concrete
anchors.
4. Line-up holes in surface with holes
in air compressor feet.
5. Place the (4) washers (supplied)
between the floor and air com-
pressor feet. If needed, solid shims
may be placed between the wash-
ers and floor to evenly distribute
weight on all four feet. See next
figure.
6. Place the (4) 3/8" lag screws
through the air compressor feet,
washers, shims, and into the
anchors.
bursting.
5/8" Washer
(supplied)
Shim Under
Washer
(not supplied)
7. Torque 3/8" lag screws to 7-10 ft.-
lbs.
9 - ENG
This compressor was
3/8" Lag
Screw
(not supplied)
Surface Line
Concrete Anchor
(not supplied)
N003195