Air Filter - Inspection And Replacement; Important; Belt - Replacement - Porter Cable CPLC7060V Manual De Instrucciones

4. Slowly add compressor oil until
the oil is even with the top of the
oil fill hole. NOTE: When filling the
crankcase, the oil flows very slowly
into the pump. If the oil is added
too quickly, it will overflow and
appear to be full.
Risk of unsafe opera-
tion. Overfilling with oil will cause pre-
mature compressor failure. Do not over-
fill.
5. Replace oil fill plug (A) and tighten
securely.
AIR FILTER - INSPECTION AND
REPLACEMENT
Hot surfaces. Risk of
burn. Compressor heads are exposed
when filter cover is removed. Allow
compressor to cool prior to servic-
ing.
keep the air filter
clean at all times. Do not operate
the air compressor with the air filter
removed.
A dirty air filter will not allow the
compressor pump to operate at full
capacity. Before using the compressor
pump, check the air filter to make
sure it is clean and in place.
If it is dirty, replace it with a new filter.
1. Using a pair of needle nose pliers
or a screwdriver pull or pry out
the old filter and carefully clean
the filter area.
2. Push the new air filter in place.
Refer to the Repair Parts for the
correct part number.
IMPORTANT: Do not operate the
compressor with the air filter removed.

BELT - REPLACEMENT

Risk of personal injury.
Serious injury or damage may occur
if parts of the body or loose items
get caught in moving parts. Never
operate the outfit with the belt guard
removed. The belt guard should be
removed only when the air compres-
sor power is disconnected.
1. Turn air compressor off, lock out
the power supply, and relieve all
air pressure from the air tank.
All manuals and user guides at all-guides.com
2. Remove the front of the belt guard
by disengaging the snaps. Insert
a flat bladed screwdriver at each
snap location and pry the belt-
guard apart.
3. Loosen the wing nut on hold
down plate and tilt motor to allow
for easy removal or installation of
the belt.
4. Remove belt.
Risk of moving parts.
Use caution when rolling belt onto
flywheel, fingers can get caught
between the belt and flywheel.
5. Replace belt. NOTE: The belt must
be centered over the grooves on
the flywheel and motor pulley.
Wing Nut
6. Turn the wing nut on the hold
down plate until it makes contact
with the washer, plus one addi-
tional turn.
7. Replace the belt guard
17 - ENG
Belt Guard
.
N003195