BGS technic 9010 Instrucciones De Uso página 22

2-2 Installation
2-2-1 Clean the mating surfaces of the fuel pump and the engine.
Replace the o-ring oil seal on the fuel pump. Fit the fuel pump and
two securing bolts at rear of the pump, tightening to 23 Nm.
2-2-2 Refit the central nut to the pump spindle, tightening to 64 Nm. Refit the two sprocket bolts and
tighten to 33Nm. Remove (C) and refit the access cover to the timing chain. Reconnect the low
pressure fuel lines and electrical connections to the fuel pump. Fit a new H.P. fuel line from the pump
to the fuel rail. Fit both end nuts finger tight, then tighten to a final torque to 35 Nm. Using main dealer
level special equipment, carry out the fuel injection pump learning procedure.
NOTIZEN
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Fig.22
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed