Dacor DRF36C500 Serie Manual Del Usuario página 46

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operations
Peak Demand Off (Override mode)
When you want the refrigerator to ignore the SMART GRID (Demand Response) signal from
the utility company, you can activate Peak Demand Off (Override mode).
When you activate Peak Demand Off (Override mode), the refrigerator ignores the SMART
GRID (Demand Response) signal and is not controlled by the utility company.
Activating and deactivating Peak Demand Off (Override mode)
1. Tap and hold
2. Then the Peak Demand Off (Override mode) icon (
3. If the refrigerator receives a SMART GRID (Demand Response) signal from the utility
company, 'Or' is displayed in the freezer temperature display.
4. To deactivate Peak Demand Off (Override mode), tap and hold
5. Then the Peak Demand Off (Override mode) icon (
NOTE
• Alternatively, you can activate or deactivate Peak Demand Off (Override mode) using
the SmartThings app and the Energy Management function. See the Using the Energy
Management Function section.
Using the Energy Management Function
The Energy Management function enables you to control and monitor your Energy
Management refrigerator using the SmartThings app for your convenience.
NOTE
• To use the Energy Management refrigerator functions, you have to install the
corresponding app first.
1. Operational Status
- You can check the DR and Peak Demand status.
2. Energy Consumption Reporting
- Shows the accumulated power consumption. Power consumption data is updated
every 10 minutes.
NOTE
The energy consumption report may differ from the power consumption specifications of
the product depending on the operating environment and the stored food.
3. Delay Defrost Capability
- The Delay Defrost Capability function saves energy by delaying the defrost
operation to a time specified by the user. You can configure the time. and this
function will save energy during the specified period in a 24 hour cycle. If the time
is not set, the function works with the default time settings. The default time settings
are below:
- 6 am to 10 am: 1st. November ~ 30th. April
- 3 pm to 7 pm: 1st. May ~ 31th. October
To change the time setting for the Delay Defrost Capability
You can change the time setting for the Delay Defrost Capability on the app.
46
English
Dacor_T-TYPE_RF7000AC_DA68-04278M-00_EN.indd 46
for 3 seconds.
) turns on.
for 3 seconds.
) turns off.
2022-04-28
10:55:36

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido