Bosch GDR18V-1860C Instrucciones De Funcionamiento Y Seguridad página 11

2610067262 GDR GDS GDX18V-1860C 07-21.qxp_GDR GDX 7/16/21 7:30 PM Page 11
holder (1) designed for impact-ready
accessories. Attach only high quality
accessories with the proper size square
drive designed for use with impact
drivers.
To install a socket (24), insert the square
output drive into the square end of the
socket. To remove, pull off output drive
(Fig. 6).
To insert a bit (21), pull locking sleeve
(2) forward, insert desired bit into bit
holder (1) and release locking sleeve. To
remove an accessory, pull locking sleeve
(2) forward and remove it from the bit
holder (Fig. 6).
Fig. 6 also shows the installation of a
screwdriver bit (21), using a hex bit
holder (23), and the installation of a
screwdriver bit with power groove (22).
Fig. 6
GDX18V-1860C
24
22
21
Belt clip (Optional Accessory)
position yourself to avoid entanglement
with surrounding objects. Unexpected
entanglement could cause the tool to fall
resulting in injury to the operator or
bystanders.
The optional belt clip accessory will
allow you to conveniently attach your
tool to your belt. This feature will allow
you to have both hands free when
climbing a ladder or moving to another
work area.
Assembly
1 16 2
23
21
When the tool
attached to the belt,
The belt clip (12) can be attached to
either side of the tool by securing it with
a mounting screw. Always make sure you
securely tighten the mounting screw
before use (Fig.1).
To use clip, turn tool upside down and
attach to your belt.
GCY42 Connectivity Module
installation
operating instructions included with
Bosch GCY42 connectivity module.
Operating instructions for GCY42
connectivity module include important
information not covered in this manual.
battery. Do
button/coin cells or other forms of
electrical power supply.
out properly. There is a risk of
explosion.
from children. This product contains a
lithium button/coin cell battery. If a new
or used lithium button/coin cell battery
is swallowed or enters the body, it can
cause severe internal burns and can lead
to death in as little as 2 hours. If you
think a battery might have been
swallowed or placed inside any part of
the body, seek immediate medical
attention.
connectivity module compartment. If
is
the connectivity module compartment
does not close securely, stop using the
product, remove the battery, and keep it
away from children.
'+' and '–' terminals with insulating
tape. When disposed of improperly,
lithium batteries may short, causing
them to become hot, burst or ignite.
11
To reduce the risk of
injury read the
Only use Button/coin
cell 3V lithium CR2032
not use any other
Ensure that battery
replacement is carried
Chemical Burn Hazard.
Keep batteries away
Always completely
secure the
When discarding
batteries, insulate the