LUND REVOLUTION 86521300 Instrucciones De Instalación página 4

Vehicles without tow hooks:
a. Cut out the lower section of the indented area in both sides of the plastic bumper insert to clear the
Brackets as pictured, (Figure 4a). NOTE: Hold the Mounting Bracket up to the back of the bumper to
determine area to cut to clear Bracket. IMPORTANT: Make several small cuts for best fit.
b. Insert the Mounting Brackets through the openings in the bumper to check for clearance around
Brackets and hardware. Trim the plastic as required to clear the Brackets.
3. Select the driver/left Mounting Bracket. Hold the Bracket up to the bottom of the frame. Line up the holes
in the Bracket with the (2) mounting bolt holes for the tow hook. Note: If your vehicle has a lower plastic
cover, you will need to trim it.
To Trim the Lower Plastic Cover:
a. Cut out the lower section of the indented area in both sides of the plastic bumper insert to clear the
Brackets as pictured, (Figure 4b). NOTE: Hold the Mounting Bracket up to the back of the bumper
to determine area to cut to clear Bracket. IMPORTANT: Make several small cuts for best fit.
b. Insert the Mounting Brackets through the openings in the bumper to check for clearance around
Brackets and hardware. Trim the plastic as required to clear the Brackets.
(Fig 4a) Models without tow hooks, cut
openings in lower plastic cover to clear
Brackets
(Fig 4b) Models with tow hooks, cut openings in
lower plastic cover to clear Brackets
3
I-Sheet Number 20263 Rev.A
REVOLUTION™ BULL BAR
2019 FORD RANGER